ADAS Plotted Variable Description
Note: Coordinated Universal Time (UTC) is 5/6 hours ahead of CDT/CST.
Quick menu:
Surface Plots,
Stability and Shear Plots,
X-Z cross-sections,
Y-Z cross-sections,
Wx-o-gram:
Notices about known ADAS operational problems, if any.
ARPS Data Analysis System Surface Plots
-
Temperature: Surface temperature converted to degrees F.
The analysis is done using potential temperature, so some
features that may look like noise are due to variations in the surface terrain.
-
Dew Point: Surface moisture converted to dew point in degrees F.
The moisture analysis is done in terms of RH*, where RH*=sqrt(1-RH)
-
Equiv Potential Temperature: Theta-e in degrees K.
-
Pressure: Sea-level pressure in mb.
Pressure reduction to sea-level is done using the surface pressure and
the 700-850mb temperature lapse rate
as documented in Benjamin and Miller, 1989, Mon. Wea. Rev., pg. 2099.
-
Wind: Wind vectors, scale in m/s is plotted in the lower-left corner.
-
Divergence: Surface divergence in 1/s * 1000.
-
Vorticity: Surface vorticity in 1/s * 1000.
-
Moisture Flux Convergence: Surface moisture flux convergence in g/kg/s * 1000.
Stability and Shear Plots
-
Lifted Index: Temperature at 500mb minus that of surface parcel (1-level) raised to 500mb. Degrees K. Positive is stable, negative is unstable.
-
CAPE: Convective Available Potential Energy, J/kg. Large positive values are most unstable. Negative values are not plotted -- see CIN.
-
CIN: Convective INhibition: Negative energy to be overcome by
forced lifting of surface (1-level) parcel if CAPE is to be realized, J/kg.
Plotted as negative number, and only where CAPE is positive.
-
Bulk Richardson Number (BRN): CAPE divided by the
boundary-layer-to-6 km AGL shear squared, unitless. Here the boundary
layer is defined as
the mean wind in the layer 0-500 m AGL. High numbers mean low shear
and or
high CAPE, suggesting air-mass type thunderstorms. Low numbers (<30)
imply low CAPE, storms may not form or may whither due to mixing in high shear.
Moderate numbers (30-60) suggest supercell storms may be supported.
(See Weisman and Klemp, 1982, Mon. Wea. Rev, pg. 504).
-
BRN (BL-6km) Shear Shear (m/s) used in BRN calculation.
-
Storm-relative Helicity Helicity (m2/s2) using a storm motion
that depends on the 0-6 km AGL mean wind -- the variation from the mean
wind depends on the speed of the mean wind. For low speeds (< 8 m/s),
there is a 32 degree deflection to the right at 75% of the speed,
which linearly ramps to a 18 degree deflection to the right at 89% of
the speed as the speed approaches 20 m/s.
-
Storm-relative Low-level Flow Storm motion is computed from
the 0-6 km AGL mean wind (see Storm-relative Helicity)
and subtracted from the mean wind in the 0-2 km AGL layer.
Magnitude in m/s is plotted.
10 m/s or higher is a desired value for supercell support.
(see Thompson, 1996, Preprints, 18th Severe Storms Conf, pg. 362,
and Droegemeier et al., 1993, Mon. Wea Rev., pg. 2005.)
-
Storm-relative Mid-level Flow Storm motion is computed from
the 0-6 km AGL mean wind (see Storm-relative Helicity)
and subtracted from the mean wind in the 2-9 km AGL layer.
Magnitude in m/s is plotted.
10 m/s or higher is a desired value for supercell support.
(see Thompson, 1996, Preprints, 18th Severe Storms Conf, pg. 362,
and Brooks et al, 1994, Mon. Wea. Rev., pg 126.)
X-Z Cross-Sections
-
Wind and Potential Temp y=432: Wind vectors and potential
temperature (degrees K) in west-to-east slice through
the southern Texas panhandle and southern Oklahoma.
-
Wind and Potential Temp y=648: Wind vectors and potential
temperature (degrees K) in west-to-east slice through
the Oklahoma panhandle and northern Oklahoma.
-
Vertical Vel and Rel Humidity y=432: Vertical velocity
(m/s, solid is upward motion, dashed downward) and relative humidity
(colors, percent) in west-to-east slice through
the southern Texas panhandle and southern Oklahoma.
-
Vertical Vel and Rel Humidity y=648: Vertical velocity
(m/s, solid is upward motion, dashed downward) and relative humidity
(colors, percent) in west-to-east slice through
the Oklahoma panhandle and northern Oklahoma.
Y-Z Cross-Sections
-
Wind and Potential Temp x=432: Wind vectors and
potential temperature (degrees K) in south-to-north slice through
northwest Texas, western Oklahoma and western Kansas.
-
Wind and Potential Temp x=603: Wind vectors and
potential temperature (degrees K) in south-to-north slice through
northeast Texas, eastern Oklahoma and eastern Kansas.
-
Vertical Vel and Rel Humidity x=432: Vertical velocity
(m/s, solid is upward motion, dashed downward) and relative humidity
(colors, percent) in south-to-north slice through
northwest Texas, western Oklahoma and western Kansas.
-
Vertical Vel and Rel Humidity x=603: Vertical velocity
(m/s, solid is upward motion, dashed downward) and relative humidity
(colors, percent) in south-to-north slice through
northeast Texas, eastern Oklahoma and eastern Kansas.
Quick menu:
Surface Plots,
Stability and Shear Plots,
X-Z cross-sections,
Y-Z cross-sections,
Return to ADAS main page.
Comments or problems? email Keith Brewster